Product features
Top
Charging the battery
Pairing your controller
Rapid Fire Wireless Controller
Before you use the controller for the first time, or after you have
not used it for a long time, you must charge the battery. (If the
controller will not be used for long periods of time, the battery
should be recharged at least once every six months.) It takes
approximately 3.5 hours to fully charge the battery.
Before you use your controller, you need to pair it with your PS3
console.
Congratulations on your purchase of a new Rocketfish Rapid Fire
Wireless Controller. This controller was designed with input from
gamers and includes some exciting new features:
1
Connect the USB cable between your controller and PS3
console.
PS
2
Turn on the controller, then press its PS button. When the PS3
recognizes your controller, all the port indicators flash slowly.
•
A modified design: better stick placement; a responsive,
one-piece directional pad; improved handle ergonomics, and
one-button Rapid Fire
To charge the battery
1
Insert the mini-USB plug on the charging cable into the USB
port on the front of the controller.
4
3
2
1
•
•
•
•
TouchSense®, dual rumble motors for lifelike vibration
Wireless connectivity to your PS3™ console
Power up your PS3™ console directly from the controller
A built-in, rechargeable NiMH battery
When your controller has been
assigned to a port, the indicator
number for the port turns solid red.
#
1
2
3
4
5
6
Description
PS button
Select button
Left stick
Rapid Fire button
Directional pad
Start button
#
7
8
9
10
Description
button
button
button
button
4
3
2
1
Package contents
•
•
Wireless controller with a built-in, rechargeable battery
9 ft. (2.74 m) USB charging cable
IMPORTANT: Make sure that the min-USB plug is aligned correctly with
the port before inserting into the plug to avoid damaging either the port
or the plug.
11 Right stick/R3 button
12 Power switch
PS
Back
NOTE: Recharging a battery that has not been fully
discharged shortens its life.
2
Insert the USB plug into the USB port on your PS3,
which must be plugged in and drawing power.
3
Turn on your PS3. The battery starts charging
and the PS button in the middle of
the controller lights blue. When the
battery is fully charged, the PS light
3
Press the PS button again to assign a port number.
Notes:
•
Pairing and assigning controller numbers can only be done when the
PS
turns off.
system is turned on.
•
When a paired controller is used with another PS3 system, the pairing
with the original system is cleared. Pair the controller with the system
again if the controller has been used with another system.
If the controller or the system is turned off, the port indicators on the
controller turn off and the assigned number is cleared.
#
1
2
3
Description
USB port
R1 button
R2 button
#
4
5
Description
Port indicators
L1 button
•
RF-GPS3101
6
L2 button
QUICK SETUP GUIDE
|